A4 Artnet-DMX Converter dimensions:
 |
| iControl Electronics Co., Ltd www.icontrol.com.vn |
A4 ARTNET-DMX CONVERTER
USER MANUAL REV. 1
Information subject
to change without
notice. SGM and
all affiliated companies disclaim liability for any injury, damage, direct
or indirect loss, consequential or economic loss or any other loss occasioned by the use of,
inability to use or reliance on the information contained in this manual. The SGM logo,
the SGM name and all other trademarks in this document pertaining to services or
products by SGM or its affiliates and subsidiaries are trademarks owned or licensed by SGM or its
affiliates or subsidiaries.
This edition applies to firmware version 1 or later.
Overview:
The SGM A4 Artnet-DMX Converter enables Artnet-DMX control
of up to four DMX universes, or up to 20 DMX universes when (a maximum of) up to five A4s are
daisy-chained together using the Artnet input and output sockets.
The A4 can operate on 100-240 V, 50/60 Hz mains supplies. A
1-meter (3.3 ft) long power cable is hard wired to the unit; do not open the unit to replace this. The power cable may be
fitted with a power cord cap (not supplied). For permanent installation, have a qualified electrician wire the mains
cable directly to a suitable branch circuit.
Configuring an A4:
A4 units are configured using the SGM Artnet Configurator, a
Windows-based application that is available from the SGM website: http://www.sgmlight.com, or provided on portable
media with your A4 unit. The application runs on personal computers running Windows Vista or Windows 7 operating
systems.
For data communication to function, the A4 and the PC must
be on the same subnet of the same local area network (LAN) with IP addresses assigned by a router with a DHCP
server in the 2.x.x.x range (which are IP addresses used and recognised by artnet). The router itself must also be
assigned a 2.x.x.x IP address. Most routers use either the 192.x.x.x
or 10.x.x.x IP address ranges by default. Consult your
router user manual for directions about how to reset the router IP address to a 2.x.x.x value, such as 2.0.0.1. Once this has
been done, and the router has been re-booted, most routers that use DHCP will generally automatically assign 2.x.x.x
addresses to the fixtures connected to their LAN.
See the SGM Artnet Configurator User Manual (available from
the SGM website: http://www.sgmlight.com), for further instructions on how to configure and use the A4 using the
SGM Artnet Configurator.
Physical data connection:
The fixture has four 5-pin DMX outputs. The pin-out on all
DMX connectors is pin 1 = shield, pin 2 = cold (-), pin 3 = hot (+), pin 4 = data 2 cold (-) and pin 5 = data 2 hot (+).
RJ45 input and output sockets are provided for artnet
support and the pinout conforms to artnet/ethernet standards.
 |
| iControl Electronics Co., Ltd www.icontrol.com.vn |
Service:
There are no user-serviceable components in the device. Do
not open the A4, as doing so is likely to damage it.
Consult your SGM dealer if the device operates abnormally,
is defective or otherwise in need of service or repair.
No comments:
Post a Comment